Partsam 20Pcs 4.7mm-12v Car White Mini Bulbs Lamps Indicator Cluster Speedometer Backlight Lighting

Easy install, arrived quickly and are functional. I mounted the light strips to the back of my mirrors after wrapping the wire around the brackets/bars supporting the mirrors. The mirror backing has an angle but the light contours and stays on. Spliced into original turn signal wires after testing with a simple 12v test light. (Strangly my used bike didn't have original turn signals )

Bought these to replace some burnt out factory bulbs in my 2006 Silverado. Took off the dash bezel, removed the cluster and soldered in the new bulbs, took me about 25-30 minutes for the whole replacement. Be sure to keep your soldering gun clean, add solder to the board and LED lights and it will make things much easier. 5 out of 5 for sure!

Very simple and easy to install! Good product!??

very bright! after installing them on my dash, i can turn the dimmer switch all the way to off and the light is still bright enough to drive by very easily. nice and long wires for easy installation. my first time soldering anything to a circuit board and they turned out great

Installed these on the passenger foot rests as turn signals on my Honda f4i so I could remove the bulky old turn signals and stream line the back of the bike more. Install was easy. The lights work nicely and are about the same brightness as the old turn signals. I had to wire in a resistor with each LED to stop the hyperflash. Also siliconed the ends to be safe. Only reason for the for four stars is because the lights themselves are completely clear so you can see the insides and it looks a bit cheap then. My fix to that is going to be to cover them with vinyl wrap and cut out the light parts. Second the wires are 20 gauge and hard to wire in because they are so small. But overall a good buy and perfect fit for what i needed them for.

Very nice material, right how they described it, wires look safe from water or anything else, I am very satisfied

Disassembled cluster yesterday. My new lights arrived while I was at work today and could not have been more excited, all day. Got home and got to work on testing them before installing them. Simple stupid I tell ya, took all of 25 mins to put all 11 of the new bulbs in. I did a mix of white and blue. Very pleased with the outcome. Ordered the right ones for the climate control after I installed the cluster. Now time for the rest of the dash and steering wheel buttons.

Bright, perfect size for a 2007 r6

Great little lights. I used these to replace the burned out bulbs in my radio and heater controls in my 99' Suburban.

These made my car's gauge cluster look like a more modern car. They're very bright and seem to have a very good light spread. I had to turn my gauge lights almost all the way down to keep things reasonable. I ended up cutting the wire feeding my gauge lights and added some resistors to get better dimming. I also had to upgrade some other lights because they were so dim in comparison to these.I chose the white color, but things ended up a bit blue due to the coloring the manufacturer used in the gauges to make yellow incandescent bulbs look white.

These LED lights are super easy to install. My husband installed them in the fender wells on our ATV. The LEDs are completely encased in a rubber or silicone, so no worries about moisture. There are only two wires to hook up, making the wiring part easy. The two wires are in a black insulation jacket over the coating on the wires. He had to trim this insulation back to strip the wires a little more, since he used connectors instead of soldering the wires. The double sided tape stuck really well to the plastic fenders. Where he placed them, they are on a slight curve. They formed to the curve well. I received this item for free in exchange for my honest review. All opinions are my own, and I always update my review if my opinion about a product ever changes.